002
2503500500
Donald^^11
Application Note
This guide is for you
to construct a network between
wired and wireless network with the Access Point.
This sheet will guide you how to install Access Point
mode and Station/Bridge
step by step.
If you encounter problems during the
installation, please refer to your User Manual.
Introduction
The Access Point can swap between these two
modes: Access Point and Station/Bridge
. In this
application note, we will give two examples to show
you how to construct a network with the two modes of
the Access Point. Figure 1 is the example of
connecting two networks wirelessly. Figure 2 is the
application of u
sing the Access Point as an access
point repeater.
Note: To have your Access Point switched
Access Point mode and the Station/Bridge
please refer to the AP Station Upgrade Quick Guide
WA1300 Bridge/Station
WA1300 Access Point
Mac II
PC
LAN
Figure 1: Connect two networks wirelessly
WA1300 Access Point
WA1300 Bridge/Station
WA1300 Access Point
Notebook
Notebook
Figure 2: AP Repeater
Figure 3: Installation Diagram
Application 1: Connect Two Networks Wirelessly
System Requirements
a) Two Access Point devices. One sets to
mode and the other sets to Station/Bridge mode.
b)
One or more PCs (desktop or notebook) with Ethernet
interface. Set its IP address, for example,
192.168.1.200 and Subnet mask to 255.255.255.0.
c) TCP/IP protocol must be installed on all PCs.
d) Network cables. Use standard 10/100BaseT networ
(UTP) cables with RJ45 connectors.
e) Microsoft Internet Explorer 5.0 or later
Navigator 4.7 or later.
Installation Instructions
a) Use straight LAN cable to connect the Access Point
one LAN, and Station/Bridge with the other.
shows the placement.
b) Connect the power adapter to the power jacks on
Access Point and Station/Bridge.
c) Open the Web browser to enter the Access Point
management page, and then set the Network Name
Access Point to, for example, wirelesslan
shows the Access Point
Web management configuration
page.
Figure 4: Access Point Web management configuration page
d) In the Station Web management page, set the
Name of Station/Bridge to wirelesslan
the Station Web management configuration page.
Figure 5: Station Web management configuration page
Once you have configured all of the PCs on your network with
appropriate
values, the setup and installation of connection
between two networks are complete.
Commentaires sur ces manuels